Part number | 7500TSN528G | |
---|
EAN | 07316574564835 | |
---|
Unit | Set | |
---|
Details | - Generates less friction and can accommodate higher shaft speeds compared to double-lip seals
- Made from an injection moulded thermoplastic polyether ester elastomer (TPE)
| |
---|
Application range | - Use as a replacement for double-seals in the size range 507 to 522
- Suitable for peripheral speeds of up to 13 m/s
| |
---|
Properties | - Easy to mount
- The maximum permissible misalignment of the shaft relative to the housing is approximately 1° for diameters up to 100 mm and approximately 0,5° for larger shafts
- The permissible axial movement of the shaft relative to the housing is not limited by the seal
| |
---|
Technical info | - The counterfaces for the seals on the shaft should be ground and the surface roughness Ra should not exceed 3,2 μm
- The recommended shaft tolerance is h9
| |
---|
Benefits | - Highly effective
- Wear-resistant and with very good elastic properties
| |
---|
Inside diameter | 125 mm | |
---|
Outside diameter | 185,1 mm | |
---|
Consists of | 2 seals (4 halves) | |
---|
Width | 16 mm | |
---|
Lip material | Thermoplastic polyether ester elastomer (TPE) | |
---|
Min working temperature | -40 °C | |
---|
Max working temperature | 100 °C | |
---|